BDP - 3 Phase Supply Monitoring Relay

BDP - 3 Phase Supply Monitoring Relay

Main Image
Product Videos
Video

Application: Supply Monitoring Relay.

Description:

The BDP supply monitoring relay offers the user a device to detect the following:

a.    Under-Voltage with a trip level factory set at 75% of nominal supply voltage

b.    Phase reversal to monitor phase sequence

c.     Phase imbalanced with a fixed trip level of 35% of the nominal phase voltage.

d.    A fixed trip delay of 0.5 seconds to help prevent nuisance tripping.





Selection:

For the product to suit your application please see the selection chart below or contact sales:
Use Filter menus to browse products - 1 Filter(s) Set
ProdRefSupply VoltageU/V Trip LevelImbalance Trip LevelPhase RotationTrip Delay TimeopenRelay ContactsEnclosure Typeenclosure type
BDP1403add to basket415Vac75%35%Yes0.5 secs1 pole C/O1
BDP1603add to basket415Vac75%35%Yes0.5 secs2 pole C/O1
BDP2403add to basket415Vac75%25%Yes0.5 secs1 pole C/O1
BDP2603add to basket415Vac75%25%Yes0.5 secs2 pole C/O1


Trip Delay Timer
Where fitted the ‘Trip Delay Timer’ will inhibit the output contacts from releasing immediately a fault is detected.
The trip delay time is adjustable up to either 10 or 30 seconds depending on the model and will be either a ‘Standard’ delay or a ‘True’ delay type.
The 'Standard' delay type will require around 50% nominal supply voltage to be maintained for its operation, in the case of a total loss of power the unit
will trip with a minimal delay of approximately 0.5 seconds. This type of timer will allow the unit to ride through a short term voltage dip but not a total
power loss.
The 'True' delay timer is not dependent on the supply voltage for its operation. The timing function will be available in the case of either a partial or total
supply failure. This type of timer will allow the unit to ride through either a short term voltage dip or a total loss of power lasting up to 30 seconds.
Power On Delay Timer
Where fitted, the ‘Power On Delay Timer’ will delay the output contacts from energising immediately the supply voltage is applied to the unit for a period
of up to 30 seconds.
The supply voltage will have to satisfy the conditions set by the supply monitoring relay for a healthy supply continuously for the ‘Power On Delay’ timing
period before the output contacts will energise.
If the unit detects a fault and releases the output contacts the supply voltage will once again have to satisfy the requirements of a healthy supply continuously
for the ‘Power On Delay’ timing period before the output contacts will re-energise.