BCE - 3 Phase Supply Monitoring Relay

BCE - 3 Phase Supply Monitoring Relay

Main Image
Application: A supply monitoring relay that provides accurate detection of under-voltage supply faults on a 3 phase mains supply.

Description

A supply monitoring relay, enclosed in a PVC enclosure to IP55, to detect voltage errors in any one or combination of phases. Under-voltage trip level and reset hysteresis levels are operator adjustable.




Selection:

For the product to suit your application please see the selection chart below or contact sales:
Use Filter menus to browse products - 1 Filter(s) Set
ProdRefSupply VoltageU/V Trip LevelPhase RotationTrip Delay TimeopenRelay ContactsEnclosure Typeenclosure typeIsolators & Fuses
BCE3103add to basket415Vac70-95%No 0.5 secs2 pole C/O3No
BCE3603add to basket415Vac70-95%Yes0.5 secs2 pole C/O3No
BCE3903add to basket415Vac70-95%Yes0.5 secs1 pole C/O4Yes


Trip Delay Timer
Where fitted the ‘Trip Delay Timer’ will inhibit the output contacts from releasing immediately a fault is detected.
The trip delay time is adjustable up to either 10 or 30 seconds depending on the model and will be either a ‘Standard’ delay or a ‘True’ delay type.
The 'Standard' delay type will require around 50% nominal supply voltage to be maintained for its operation, in the case of a total loss of power the unit
will trip with a minimal delay of approximately 0.5 seconds. This type of timer will allow the unit to ride through a short term voltage dip but not a total
power loss.
The 'True' delay timer is not dependent on the supply voltage for its operation. The timing function will be available in the case of either a partial or total
supply failure. This type of timer will allow the unit to ride through either a short term voltage dip or a total loss of power lasting up to 30 seconds.
Power On Delay Timer
Where fitted, the ‘Power On Delay Timer’ will delay the output contacts from energising immediately the supply voltage is applied to the unit for a period
of up to 30 seconds.
The supply voltage will have to satisfy the conditions set by the supply monitoring relay for a healthy supply continuously for the ‘Power On Delay’ timing
period before the output contacts will energise.
If the unit detects a fault and releases the output contacts the supply voltage will once again have to satisfy the requirements of a healthy supply continuously
for the ‘Power On Delay’ timing period before the output contacts will re-energise.