JAP3 - 3 Phase Current Monitoring Relay

Application: 3 Phase Current Monitoring Relay

Description:

The JAP3 family offers a true 3 phase current sensing relay, providing accurate detection of both under and over-current conditions on any one or combination of phases in a 3 phase power system.

Features include:
•3 Fully isolated current sensing inputs
•2 output relays allow both under and over-current faults
•User friendly adjustable under and over-current trip levels.

Selection:

For the product to suit your application please see the selection chart below or contact sales:

Show Advanced Filters

Use Filter menus to browse products -

1 Filter(s) Set

ProdRef	Control Supply	Monitored Phases	U/C Trip Level	Trip Delay Time	Relay Contacts	Separate U/C and O/C Contacts	Current Rating	Enclosure Type	O/C Trip Level

JAP3601	110Vac	3	20-100%	0.2 secs	2 pole C/O	Yes	1A ac	2	50-200%
JAP3701	110Vac	3	20-100%	0.2 - 10 secs	2 pole C/O	Yes	1A ac	2	50-200%
JAP3801	110Vac	3	20-100%	0.2 secs	2 pole C/O	Yes	5A ac	2	50-200%
JAP3901	110Vac	3	20-100%	02 - 10 secs	2 pole C/O	Yes	5A ac	2	50-200%

Trip Delay Timer
Where fitted the ‘Trip Delay Timer’ will inhibit the output contacts from releasing immediately a fault is detected.
The trip delay time is adjustable up to either 10 or 30 seconds depending on the model and will be either a ‘Standard’ delay or a ‘True’ delay type.
The 'Standard' delay type will require around 50% nominal supply voltage to be maintained for its operation, in the case of a total loss of power the unit
will trip with a minimal delay of approximately 0.5 seconds. This type of timer will allow the unit to ride through a short term voltage dip but not a total
power loss.
The 'True' delay timer is not dependent on the supply voltage for its operation. The timing function will be available in the case of either a partial or total
supply failure. This type of timer will allow the unit to ride through either a short term voltage dip or a total loss of power lasting up to 30 seconds.

Power On Delay Timer
Where fitted, the ‘Power On Delay Timer’ will delay the output contacts from energising immediately the supply voltage is applied to the unit for a period
of up to 30 seconds.
The supply voltage will have to satisfy the conditions set by the supply monitoring relay for a healthy supply continuously for the ‘Power On Delay’ timing
period before the output contacts will energise.
If the unit detects a fault and releases the output contacts the supply voltage will once again have to satisfy the requirements of a healthy supply continuously
for the ‘Power On Delay’ timing period before the output contacts will re-energise.